Removing the Shelly Wave Devices from the Gateway
Removing (exclusion) with the Switch / Push-button
Connect the Device to a power supply (if it is not connected yet).
Check if the green LED is blinking. If so, the Device is added to a Z-Wave™ network.
Enable remove / exclude mode on the gateway.
Toggle the switch / push-button connected to any SW terminal-s (SW, Sw1, Sw2, etc.) 3 times quickly. The Device must receive on/off signal 3 times, which means pressing the momentary switch 3 times, or toggling the switch on and off 3 times.
The blue LED will be blinking faster during the removing process.
The blue LED will be blinking slower if the Device is successfully removed from a Z-Wave™ network and all Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load connected to the output 1s on / 1s off, 1s on / 1s off, if the device is successfully removed from a Z-Wave network.
Note! The Device will be removed from your Z-Wave™ network, but any custom configuration - parameters will not be erased.
Removing (exclusion) with the S button
Connect the Device to a power supply (if it is not connected yet).
Check if the green LED is blinking. If so, the Device is added to a Z-Wave™ network.
Enable remove / exclude mode on the gateway.
To enter the Setting mode*, quickly press and hold the S button on the Device until the LED turns solid blue.
Quickly release and then press and hold (> 2s) the S button on the Device until the blue LED starts blinking faster. Releasing the S button will start the exclusion.
The blue LED will be blinking faster during the removing process.
The blue LED will be blinking slower if the Device is successfully removed from a Z-Wave™ network and all Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load connected to the output 1s on / 1s off, 1s on / 1s off, if the device is successfully removed from a Z-Wave network.
Note! The Device will be removed from your Z-Wave™ network, but any custom configuration - parameters will not be erased. *Note! In Setting mode, the device has a timeout of 10s before entering into Normal mode.