Adding the Shelly Wave Devices to the Gateway
Adding with SmartStart*
SmartStart enabled products can be added into a Z-Wave™ network by scanning the Z-Wave™ QR Code present on the Device with a gateway providing SmartStart inclusion. No further action is required, and the SmartStart device will be added automatically within 10 minutes of being switched on in the network vicinity.
With the gateway application scan the QR code on the Device label this will add the Device to the provisioning list in the gateway.
Connect the Device to a power supply (if it is not connected yet).
Check if the blue LED is blinking. If so, the Device is not added to a Z-Wave™ network.
Adding will be initiated automatically within a few seconds after connecting the Device to a power supply, and the Device will be added to a Z-Wave™ network automatically.
The blue LED will be blinking faster during the adding process.
After that the green** LED will be blinking if the Device is successfully added to a Z-Wave™ network and all Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load connected to the output 1s on / 1s off, 1s on / 1s off, if the device is successfully added from a Z-Wave network.
* To add the device using SmartStart, you will need to ensure that the gateway supports this feature. ** Valid only for the Wall Plug US, the colour of the blinking LED is violet.
Adding with the S Button
Connect the Device to a power supply (if it is not connected yet).
Check if the blue LED is blinking. If so, the Device is not added to a Z-Wave™ network.
Enable add / include mode on the gateway.
To enter enter the Setting mode, press and hold the S button on the Device until the LED turns solid blue. Release and then press and hold (> 2s) the S button on the Device until the blue LED starts blinking faster. Releasing the S button will start the Learn mode*.
The blue LED will be blinking faster during the adding process.
After that the green** LED will be blinking if the Device is successfully added to a Z-Wave™ network and all Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load connected to the output 1s on / 1s off, 1s on / 1s off, if the device is successfully added from a Z-Wave network.
* Learn mode - a state that allows the Device to receive network information from the gateway ** Valid only for the Wall Plug US, the colour of the blinking LED is violet.
Adding with the Switch / Push-button
Connect the Device to a power supply (if it is not connected yet).
Check if the blue LED is blinking. If so, the Device is not added to a Z-Wave™ network.
Enable add / include mode on the gateway.
Toggle the switch/push-button connected to any of the SW terminals (SW, SW1, SW2, etc.) 3 times quickly (this procedure puts the Device in Learn mode*). The Device must receive on/off signal 3 times, which means pressing the momentary switch 3 times, or toggling the switch on and off 3 times.
The blue LED will be blinking faster during the adding process.
After that the green** LED will be blinking if the Device is successfully added to a Z-Wave™ network and all Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load connected to the output 1s on / 1s off, 1s on / 1s off, if the device is successfully added from a Z-Wave network.
* Learn mode - a state that allows the Device to receive network information from the gateway ** Valid only for the Wall Plug US, the colour of the blinking LED is violet.